FAQ:Power Cab and JMRI
DCCWiki, a community DCC encyclopedia.
See more FAQs | |
---|---|
General information | |
DCC Categories | Computer, Computer Interface |
Related Articles: | |
Manufacturers |
If JMRI will not connect to the Power Cab using the NCE USB, try the following steps:
- Disconnect all cabs except the Power Cab first.
The best settings for any version of the Power Cab and NCE USB:
- All USB Jumpers OFF. Jumper #1 is ignored, but jumpers 2, 3 and 4 should be Off.
JMRI Preferences:
- System Manufacturer: NCE
- System Connection: NCE USB
- Serial Port: This is determined by the port the USB device is connected to
- USB Version: V7.x.x
- System: PowerCab
- Additional Connection Settings: Select this to get the next setting:
- Baud Rate:9600
- (Setting to another bit rate will cause issues.)
- Baud Rate:9600